New Balance Headphones NB447 User Manual

Model: NB447  
Sport Ear Buds with  
Modular Cord System  
Using Your New Balance Sport Ear Buds with Foldable Head Band  
Your New Balance Ear Buds feature a foldable headband for compact storage. Unfold the headband  
completely, place it over your head and insert the “L” ear bud in your left ear and the “R” ear bud in your  
right ear. Adjust the length of the headband for the most comfortable and secure fit.  
Your New Balance Sport Ear Buds were designed with a modular cord  
system. We have provided a 15” iPod/iPhone control cable that is  
suitable if your music player will be worn in an armband or clipped to your  
clothing at chest level. We have also provided a 36” cable that is suitable  
if your music player will be clipped to your belt, placed in your pocket or  
carried in a fanny-pack. You may connect both cables together in case  
you want to control your iPod or iPhone and the 15” cable is not long  
enough.  
Connect the male headphone plug of the ear buds to the female headphone jack of either the 15” or 36”  
headphone cable depending on your wearing preference. Then connect the male headphone plug of the  
15” or 36” cable to the headphone jack of your music player. Be sure that the plugs are fully inserted into  
the jacks. If the plug is not fully inserted you may only hear sound from one earpiece.  
Using the iPod/iPhone Control Cable  
Connect the 15” iPod/iPhone cable between your headphones and your iPod/iPhone to perform the  
following operations with the remote controller mounted on the cable:  
Master Control  
Click to Increase  
Volume  
Click x2 for Next Track  
Click x3 for Previous Track  
Click to Play/Pause  
Click to Decrease  
Volume  
Press + Hold for iPod  
Shuffle VoiceOver  
To Do This  
Action Required  
Activate voice control*  
Answer or end a call  
Depress the Master Control for 2 seconds  
Press the Master Control once to answer call  
Press the Master Control again to end call  
Ignore an incoming call  
Depress the Master Control for 2 seconds  
Answer a second incoming call  
and place original call on hold  
Press the Master Control once to answer second call  
Press the Master Control again to return to first call  
Answer a second incoming call,  
and end original call  
Depress the Master Control for 2 seconds  
2 low tones will confirm end of original call.  
Switch between two calls  
Play or Pause  
Press the Master Control once to switch between calls  
Press Master Control once to Play, again to Pause  
Press Master Control 2 times quickly  
Skip Track or Chapter Forward  
Skip Track or Chapter Back  
Press Master Control 3 times quickly  
Increase Volume  
Decrease Volume  
Press the "+" button  
Press the " - " button  
Activate VoiceOver**  
Press and hold the Master Control to hear title and  
artist of currently playing song  
Navigate Playlists using VoiceOver**  
Press and hold the Master Control until tone is heard,  
then release. When the name of the desired playlist is  
heard, press the Master Control once to select it.  
Using the Accessory Cord Winder Clip  
Your New Balance Ear Buds are also supplied with a cord winder clip that may be used to eliminate excess  
slack in the 36” cable if necessary. If you find that that the 36” cable is too long you can store up to 24” of  
cable in the cord winder and then clip the cord winder to your clothing.  
 
open the cord winder  
using the small tab  
under the clip  
pass the plug down  
and through the cover  
pull the cord back up  
and over the spool  
clip it on and go!  
close the cord winder  
wrap cord clockwise around the  
spool to reach desired length  
wind over  
20 inches!  
Using the Water Resistant Connection Cover  
Your New Balance Ear Buds are also supplied with a silicon sleeve that can be used to cover the  
connection between the male headphone plug on the Ear Buds and the female headphone jack on the 15”  
or 36” cable. Use this connection cover if you routinely use your Ear Buds in extremely wet or damp  
conditions.  
Stretch the connection cover over the plug of the Ear Buds as shown.  
After connecting the male plug of the Ear Buds to the female jack on the  
15” or 36” cable. Slide the connection cover down so that it completely  
covers the plug and jack connection point to seal out excess moisture.  
Safety Information  
To protect your hearing, always start listening with the Volume Control of  
your music player set to a low level and gradually increase the volume to  
a comfortable listening level.  
IMPORTANT! Listening at high volume for long periods of time can result  
in long-term hearing damage. For your safety, do not use headphones if  
they would prevent you from hearing warning sounds, such as while  
driving a car or motorcycle, riding a bike, etc.  
NOTE: In extremely cold or dry air conditions you may notice a slight  
‘tingling’ feeling in your ears when using in-ear headphones. This is the  
result of the build-up of static electricity in your body. This is normal and  
not an indication of any problem with your headphones.  
 

Miele Electric Pressure Cooker DA 3160 User Manual
Mini Automobile COOPER User Manual
Mr Coffee Coffeemaker CUBIKA User Manual
MTD Edger Series 521 User Manual
Multiquip Heat Pump c 30hdn User Manual
Nokia Computer Monitor LS 2 User Manual
Nokia Range 9362065 User Manual
Optoma Technology Projector EP706 User Manual
Oregon Scientific Automobile Accessories IBM80010 User Manual
Ozaki Worldwide Portable Speaker Dotadot500 User Manual